Herbicide Carryover Injury Applications Of Herbicides

May 15, 2014

By Kevin Bradley

Over the past two days, I’ve received numerous calls of herbicide carryover injury from applications of herbicides that contain fomesafen made last season.  

Fomesafen is the active ingredient in the herbicides Dawn, Flexstar, Flexstar GT, Prefix, Rhythm, Marvel and a variety of other generic products, and in recent years has become one of the most common active ingredients applied post-emergence for the control of glyphosate-resistant waterhemp in soybean. Of the herbicides that we typically apply post-emergence in soybeans, fomesafen is one of the most persistent and has one of the longest periods of soil residual activity. Because of this soil persistence as well as the sensitivity of corn to fomesafen residues, the label of most fomesafen products like Flexstar and Prefix requires a 10-month rotational interval between fomesafen applications and corn planting.  

For some of the calls and complaints I’ve had this week related to fomesafen carryover, this 10-month rotational interval between application and planting was not followed.  However, in some of these instances, there has been more than 10 months elapsed between application and planting.

There are two primary factors that influence the likelihood of fomesafen carryover injury to corn; 1) dry conditions following application, and 2) the rate and timing of the herbicide application.  I also think that we should consider the impact of our colder-than-normal winter on fomesafen carryover.  I can’t find any research data to support this, but it makes sense to me that microbial degradation may have been reduced in response to the extended winter we just experienced.

There’s no question though that the number one factor that influences the likelihood of fomesafen carryover is precipitation between application and planting.  Soil moisture is critically important for herbicide degradation.  If adequate rainfall is not received after application, then the chemical and microbial processes responsible for herbicide degradation are reduced significantly and the herbicide molecules are more likely to become bound (adsorbed) to soil particles.  All of this results in less herbicide degradation and increases the likelihood of herbicide carryover.  Injury may also be more noticeable on sandy soils, as these areas are usually better drained and hold moisture for shorter periods of time. In some of the locations that have reported fomesafen carryover this week, precipitation totals have been off by as much as 17 inches from the 15 year average for the time period following application to now.

The rate and the timing of the fomesafen application are two other factors that influence the likelihood of carryover injury to corn.  Simply put, the higher the rate of fomesafen applied and the later the herbicide application was made, the greater the chance that some fomesafen may remain to cause carryover injury to corn.  Since the labels of most fomesafen-containing products require a 10-month rotational interval between application and corn planting, late-season applications of these products in soybeans and early planting of corn the following spring can often make satisfying these intervals difficult.

The most common corn injury symptom caused by fomesafen carryover is a whitening of the leaf veins, commonly referred to as veinal chlorosis (Figures 1 and 2).  Affected areas of corn leaves often take on a striped appearance, can become necrotic, and tissue near the leaf midrib may totally collapse in that region.   The root system of affected plants usually remains normal, and plants can take on somewhat of a “droopy” appearance as well.

The real question everyone is asking about this issue is, “Is this going to kill my corn?”  All I can say is, I’ve rarely seen a fomesafen carryover issue in corn that is bad enough to justify killing the corn and starting over.  And I don’t believe this is warranted for any of the fields or photos I’ve seen this week either. Usually the most effective thing we can do is wait for the corn to get some good growing conditions and heat units, and the roots will grow out of that fomesafen “zone” and plants will recover.  Monitor the new growth closely in the next 5 to 7 days and as long as the new leaves have a healthy green color, you should be fine for the rest of the season.

Figure 1. Fomesafen carryover on corn leaves appears as a clearing of the veins, known as veinal chlorosis.