How To Install A John Deere 44” 100 Series Snow Blower

Jan 24, 2019

Subscribe to our Newsletters

Does John Deere make snow blowers? As it turns out, there are several snow attachments Deere enthusiasts can use with their existing machines to turn them into plowing implements during the winter. The John Deere 44” 100 Series Snow Blower is one option customers may want to consider for their machinery during this time of the year. It is as efficient as it is versatile and easy to use.

Let’s look over the key steps you need to take to install a John Deere 44” 100 Series Snow Blower and how it can help you with the task at hand.

How to Install the 44” 100 Series Snow Blower




1) Before installing any attachments, recognize the safety information.

Take a moment to ensure you understand the signal words and prepare yourself to follow the instructions carefully before you begin.

2) Remove the mower deck and front bumper from your mower.

Follow the instructions in your operator’s manual for more information on how to remove these implements properly.

3) Install the front hitch.

First, find four carriage bolts and four nuts. Next, latch the front hitch mounting brackets over the top of the vehicle axle. Fasten the left bracket to the vehicle frame, and repeat for the right side. Tighten all four nuts when this step is complete.

4) Install the Belt Drive Module.

Position the belt drive module under the machine. Lift the module and latch the slats under the frame pin on each side. While holding the module, insert a carriage bolt to secure the module. Install the nut and repeat the process on the other side. Tighten the bolts accordingly.

5) Install the lift lock cable and PTO connection.

Rope the cable through the mounting slot and secure with a spring pin. If you have a manual PTO model, put the short end of the engagement spring into the tension arm hole, then put the cable through the hole on the belt drive module.

6) Line up the snowblower with the tractor to install the drive belt.

Remove the belt guide from the snowblower and route the drive belt around the pulley. Ensure that it is not twisted, then re-install the belt guide.

7) Install the snow blower housing to the tractor hitch.

Pull out both L-shaped pins and twist clockwise. Lower the front hitch so that the transport locking pin disengages. Lift the snowblower to the hitch so the yellow pins sit in the cradles. Rotate the L-pins counter-clockwise so they lock into place. Verify that both L-shaped pins are fully engaged with the snow blower housing. Raise the snowblower to transport position so that the locking pin engages.

Source : Machinefinder